bunnyscience

Site Navigation

Your Account

Choose Language

Changes to Step #18

Edit by Guy Kuo —

Edit approved by Guy Kuo

Before
After
Unchanged

Step Lines

[title] 3D Parts Post Print & Assembly
[* black] Experienced 3D printers will note this project requires minimal post print processing. Do inspect prints for stringing and remove fine stringing with heated air. Remove burrs as needed. 3 mm bolt passages are easier to use if one runs a 3 mm drill through them before assembly.
[* black] I have intentionally designed to allow operation without tight tolerances. Most ofNearly the entire HALO respirator runs under positive pressure and is not involved in gas sealingmaking even FDM manufacture practical.
[* red] Consider lapping the top and bottom of the the fan flange so it seals welltighter against bag penetrator and fan22 mm fitting.
[* green] Fan attaches to its mount and flange via M3 screws and nuts. Length of screw should be just over 5 mm longer than fan thickness.
[* icon_note] New flex fit BS Halo places fan atop head on an adjustable band
[* black] I have intentionally designed to allow operation without tight tolerances. Most ofNearly the entire HALO respirator runs under positive pressure and is not involved in gas sealingmaking even FDM manufacture practical.
[* red] Consider lapping the top and bottom of the the fan flange so it seals welltighter against bag penetrator and fan22 mm fitting.
[* green] Fan attaches to its mount and flange via M3 screws and nuts. Length of screw should be just over 5 mm longer than fan thickness.
[* icon_note] New flex fit BS Halo places fan atop head on an adjustable band

Image 1

Old Version

New Version

Image 2

Deleted