Help

Step Type:

Drag to rearrange

Draw nuts into hex pockets rather than trying to push them into position.

Be sure nut is rotationally aligned with hex recesss as you draw it in. Misalignment will damage the pocket.

Washer at bolt head reduces damage to plastic. This is especially important on the motor plate gearbox. Do not over tighten. Just get the nut fully seated. Once nut is seated, remove bolt and washer.

If POLYCARB print, use minimal force when drawing in nuts. Polycarb is more brittle than PETG and can snap. If nut will not fully seat, gently melt it into place with a 260C soldering iron tip.

Your contributions are licensed under the open source Creative Commons license.