Editing Step 66 —

Step Type:

Drag to rearrange

If single filament armature sensor, place 1050ZZ bearing on hinge bolt as spacer in place of internal sensor lever.

if MMU2S internal lever, hinge bolt goes through lever bearing then idler door

Secure tip of hinge bolt in Nylock, but don't tightly tension the bolt. It must not deform the plastics.

No white nylon washers are specified in Bunny Science design. Parts have inherent tapers to replace washers in Prusa design. However, if door has too excess play, you can add a white nylon washer.

Your contributions are licensed under the open source Creative Commons license.