Help
Editing Step 9 —

Step Type:

Drag to rearrange

Clear out linear rod mounting holes with 8 mm drill at low RPM.

Draw in M3 nut for each x-end clamp WITHOUT LMU8 bearings in place. Leaving out the bearings is VITAL during this step. This lets two sides of clamps abut and support each other during process.

With the bearings in place, clamp ends cannot abut each other during nut draw-in process. The plastic clamp WILL SNAP before nut can be drawn in.

Do not over tighten clamps when bearings inserted. The clamp gap will never close with bearings inserted. Attempting to close gas will break clamp.

Repeat for other x-end.

Your contributions are licensed under the open source Creative Commons license.