AHA! success. I moved my belt to the upper retainer on the mount plate and adjusted the x drive pulley to align better with the belt in it's new home. (It was rubbing on the motor side) Now the self test passes with no more troubles.
AHA! success. I moved my belt to the upper retainer on the mount plate and adjusted the x drive pulley to align better with the belt in it's new home. (It was rubbing on the motor side) Now the self test passes with no more troubles.
I very much wish I had read this before printing and installing the Bear ends. I am getting a full 250mm travel on the X-axis but the new firmware 3.12.2 has hung up on me because the self test fails. I gets as far as the X-axis check and fails right afterward. I think it sees too much movement from end to end. At the time I am writing this I have not yet solved the issue but I will get it done and try to get the solution posted here after.
Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
AHA! success. I moved my belt to the upper retainer on the mount plate and adjusted the x drive pulley to align better with the belt in it's new home. (It was rubbing on the motor side) Now the self test passes with no more troubles.
this is the follow up not the original
AHA! success. I moved my belt to the upper retainer on the mount plate and adjusted the x drive pulley to align better with the belt in it's new home. (It was rubbing on the motor side) Now the self test passes with no more troubles.
I very much wish I had read this before printing and installing the Bear ends. I am getting a full 250mm travel on the X-axis but the new firmware 3.12.2 has hung up on me because the self test fails. I gets as far as the X-axis check and fails right afterward. I think it sees too much movement from end to end. At the time I am writing this I have not yet solved the issue but I will get it done and try to get the solution posted here after.